Ebode BTR30 User Manual page 5

How to turn the BT Sound on/off
Turn on: Press the On/Off button until you hear the beep and the blue indicator light
flashes.
Turn off: Press the On/Off button for 4 seconds, until you hear 3 beeps and the blue
indicator light flashes twice. Please disregard the long beep you'll hear after 2 seconds, this
is for redialling. Read more about this on the next page.
Connect to your amplifier, stereo or car audio system
Plug one end of the audio cable in your BT Sound and the other end in the source input of
your amplifier, stereo or car audio system.
There is a convertor (Stereo to RCA Phono plug) included in the kit, in case your audio
system requires this.
After you connected the cables, you can pair the BT Sound with your Bluetooth® device.
In above pictures you can see that the BT Sound is connected to an amplifier (left), where
we've used the converter cable. In the car audio system (on the right) we've directly
connected the audio cable to our car audio system.
Pairing with your Bluetooth® Device
1. The distance between the BT Sound and your Bluetooth® Device would be best within
30 to 100 centimetre when pairing.
2. Make sure that the BT Sound is turned off.
3. Press and hold the On/Off Button until the light stays blue.
4. Search the ebode BT Sound on your Bluetooth® Device by following the Bluetooth®
Device instructions.
5. After a few second your Bluetooth® Device will list the "ebode BTR30" as a device.
Select it and follow your Bluetooth® Device instruction to complete the connection.
6. If asked, enter passkey "0000", then press "yes" or "ok".
IMPORTANT: If pairing is successful, the indicator light will flash blue 10 times rapidly before
going to flashing every 3 seconds. If unsuccessful, the light remains on, and you will need
to reattempt the pairing. If you cannot get a connection after several trials, we advise you
to change the distance between the BT Sound and you Bluetooth® device; too far away
from each other will not work, but neither when they are too close. The light will go out if
the pairing time takes more than 60 seconds. If that happens, you need to turn off the BT
Sound and turn it on for pairing again.
Disconnect the BT Sound from your Bluetooth® Device
If you want to disconnect the BT Sound from your Bluetooth® Device, just turn off the BT
15-5-2012 5 ebode BTR30