Advertisement
TROUBLESHOOTING
Most treadmill
problems can be solved by follow-
ing the simple steps below. Find the symptom that
applies, and follow the steps listed, if further assis-
tance is needed, see the front cover of this manual.
SYMPTOM: The power does not turn on
a.
Make sure that the power cord is plugged into a
surge suppressor and that the surge suppressor
is plugged into a properly grounded outlet (see
page 13). Use only a surge suppressor that meets
all of the specifications described on page 13.
iMPORTANT: The treadmill
is not compatible
with GFCl-equipped
outlets and may not be
compatible with AFCl-equipped
outlets.
b.
After the power cord has been plugged in, make
sure that the key is inserted into the console.
C.
Check the power switch located on the treadmill
frame near the power cord. If the switch protrudes
as shown, the switch has tripped. To reset the
power switch, wait for five minutes and then press
the switch back in.
c
Tripped
Reset
SYMPTOM: The console displays
remain lit when
you remove the key from the console
a.
The console features a display demo mode,
designed to be used if the treadmill is displayed in
a store. If the displays remain lit when you remove
the key, the demo mode is turned on. To turn off
the demo mode, hold down the Stop button for a
few seconds. If the displays are still lit, see THE
INFORMATION
MODE on page 18 to turn off the
demo mode.
SYMPTOM: The displays
of the console do not
function
properly
a.
Remove the key from the console and UNPLUG
THE POWER CORD. Next, remove the five indi-
cated #8 x 3/4" Screws (4).
4
1
SYMPTOM: The power turns off during use
a.
Check the power switch (see the drawing above).
If the switch has tripped, wait for five minutes and
then press the switch back in.
b.
Make sure that the power cord is plugged in. If the
power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c.
Remove the key from the console, and then
reinsert it.
d.
If the treadmill still will not run, please see the back
cover of this manual.
Carefully lift the Motor Hood (48) upward, and then
slide it forward and off. Make sure that the Motor
Hood does not get caught by the tabs on the sides
of the Motor Hood.
2O
Advertisement
