Keurig Elite B40 Owner's Manual page 6

SECTION 1
You cannot use your Keurig
IMPORTanT:
it has been primed for its first use as set forth below.
If Brewer has been exposed to temperatures
nOTE:
below freezing, allow Brewer at least two hours to
reach room temperature before priming. A frozen
or extremely cold Brewer will not prime.
Priming Your Brewer
1
fig.
Unwrap cord and plug the Brewer into a
1.
grounded outlet. Remove all pieces of
packing tape.
2. Place a Large Mug (10 oz. minimum) on
the Drip Tray Plate.
3. Remove the Water Reservoir from Brewer by
first removing Lid from Reservoir (fig. 1), then
lifting Reservoir straight up and away from
Brewer (may be tight). Rinse with fresh water.
Fill Water Reservoir with bottled or filtered
4.
water so that the water level reaches the line
just below the top edge of the clear viewing
area. (Be careful not to over fill.)
Priming & First Brew
Brewer until
® Place Water Reservoir base into the left side
5.
2
fig.
of the Brewer and be sure the Water Reser-
voir Lock Tabs engage with the Brewer (fig. 2).
Replace Lid on Water Reservoir.
Press Power Button found on upper right panel
6.
of the Brewer. The green light next to the Power
Button will become illuminated.
7. The red light next to 'DE-SCALE' on the LED
Control Center will flash to indicate the Brewer
needs to be primed. Make sure the Handle is all
the way down before continuing.
should not be used for the Priming Sequence.
8. Press the flashing Small Mug Button. (fig. )
3
fig.
NOTE: If the Water Reservoir is empty or
not in place on the Brewer, the blue light next
to 'ADD WATER' on the LED Control Center will
be illuminated. The Small Mug Button will
not be activated until water is added to the
Water Reservoir.
The Brewer will automatically fill with water
9.
(priming it) and then the water will be heated.
This will take about  minutes. During the heat-
ing period the red light next to 'HEATING' on the
LED Control Center will become illuminated.
Once the water is heated, the red light will turn
Small Mug
off and the Small Mug Button will flash.
NOTE: Do not lift the Brewer Handle while priming.

NOTE: A K-Cup