Advertisement
Available languages
Available languages
Pre-installed
f
Puck
Catcher
with Short Sensor
Wire
1 Piece
1/4" Washer
4 Pieces
Pre-installed
Battery
Box
1 Piece
Pre-installed
Square
Nut and Screw
4 Sets
Pre-installed
Top Corner
4 Pieces
Pre-installed
T - Nut
12 Pieces
Wrench
1 Piece
U
1/4" x 1-1/4" Bolt
4 Pieces
WARNING:
1) Require 4pcs AA Batteries
(Not included).
2) Do not mix old and new batteries.
3) Do not mix alkaline,
standard
(carbon zinc), or rechangeable
(nickel-cadmium)
batteries.
ASSEMBLY
iNSTRUCTiONS
1. Find a clean, level place to begin the assembly of your Air Hockey table. The table will be assembled upside down
and then turned over on its legs once the assembly completed. This game table is heavy, and tuning it over will
require at least four strong adults.
2. Remove all the parts from the box and verify that you have all of the listed parts as shown on the parts list below.
Carefully cut or tear the four corners of the box so that the bottom of the box can be used as your work surface.
3. Attach the Side Apron (#2) to the Main Cabinet (#1) using five Bolts (#24) and five Washers (#23) per Side Apron.
See FiG. 1.
5
Advertisement
