Normal Operating Noises Of The Cooktop - Bosch NIT3065UC Use And Care Manual

The display flashes (no
power) when you place
a pan on an induction
element
The SpeedBoost func-
tion display flashes and
then turnes off
and numbers A fault in the electronic system has
Display
"
and numbers A fault has been detected.
Display
"
Error messages
Display
+ number
"§
+ number
š
+ number
¡
"ƒ
"...
—‚
/
—ƒ —„
Notes
Glass ceramic may have uneven areas on the surface
▯
due to the nature of the material itself. Because of the
mirror-like finish on the cooking surface, even
extremely small bubbles less than 1 mm in diameter
may be visible. These bubbles will not have any
adverse effect on the operation of the cooktop nor on
the durability of the glass ceramic cooking surface.
Depending on the countertop that is present in the
▯
kitchen, an uneven gap between the cooktop unit and
the countertop can occur. For this reason, a flexible
seal is provided around the entire cooktop unit.
18
The pan is not ferromagnetic
The diameter of the pan is to small. Use a pan with an appropriate diameter for the ele-
The element is too hot.
occurred.
Fault
A fault in the electronic system has
occured.
The element is too hot and has
turned off.
The touch control zone is too hot.
Incorrect input voltage, not within
normal working limits.
The cooking element has over-
heated and has switched off to pro-
tect the cooktop..
Check the bottom of the pan with a magnet.
ment.
If the display still does not light up when you turn the
element off and on again, disconnect the appliance
at the circuit breaker. Wait 20 seconds and then
reconnect it.
The SpeedBoost function operates the element with
the highest possible power. During long cooking
times, it is possible that the function will turn the ele-
ment off to protect the cooktop from overheating. You
can continue to use the cooktop if the display is not
flashing.
Turn the appliance off and back on at the fuse or cir-
cuit breaker. If the same fault occurs again, discon-
nect the appliance and call Technical Assistance
Service.
The following table of error messages lists actions
you can take to correct the problem
Measure
Disconnect the cooktop from the power supply. Wait
a few seconds and then reconnect it.
If the indicator persists call Technical Assistance Ser-
vice.
Remove the pans from the elements.
when you press the display, if the element has
cooled down sufficiently. Wait a few minutes until the
element has cooled down a bit. If
after the element is turned back on, the cooktop is
still too hot. Turn off the elements and allow them to
cool further.
Make sure that cookware is properly positioned on
the element, and no hot objects are in contact with
the touch control zone. Wait a few minutes until the
touch control zone has cooled down. If
after you turn on the appliance, call Technical Assis-
tance Service.
Contact the electricity distributor.
Wait for the electronic system to cool down and then
turn the cooktop on again..

Normal operating noises of the cooktop

Induction technology is based on the creation of
electromagnetic fields. They may generate heat directly
on the bottom of the cookware. Pots and pans may
cause a variety of noises or vibrations depending on the
way they've been manufactured. These noises are
described as follows:
Low humming (like a transformer)
This noise is produced when cooking at a high heat
level. It is based on the amount of energy transferred
from the cooktop to the cookware. The noise ceases or
quiets down when the heat level is reduced.
disappears
"ƒ
appears again
"ƒ
appears
"...