YOUR WARRANTY Here's how your warranty works: JBS Technologies warrants to the original customer, in the originally installed vehicle a limited lifetime warranty, providing the system was installed by an authorized dealer. Within 12 months of purchase, JBS Technologies will repair or replace, About JBS Technologies our option, any defective system at no charge.
Remotely start your car to run the heater or air conditioning from Range Remote Transmitters an extended distance. City _________________________________ State ______ Zip Code ___________ Date of Purchase _____________________ Model: Deluxe 22I Remote Programmable Remotely program your car to start at a preset temperature.
SYSTEM FEATURES OPERATING INSTRUCTIONS Button #1: Remote starts your vehicle from up to a quarter Remote Starter Features mile. Remote Programmable Remotely program your vehicle to automatically start when the Button #2: Arm locks and disarm unlocks your power door Low Voltage Start battery voltage drops below 11 volts.
U.S.A. The dependability and variety of 25 minutes, 5 flashes. Simply release button at whatever runtime you desire. To check features make Bulldog Security Security the leader in the industry. programmed runtime, press and release Button #4 (Stop). The parking lights will flash for the amount of runtime you have programmed the unit for.
PRECAUTIONS PROGRAMMING INSTRUCTIONS Programming Tach Learn This system is designed to be used with fuel-injected and diesel Press and hold the brake, then press and hold Button #2 until the parking lights flash twice. vehicles with automatic transmissions only. Release Button #2. NOTE: The unit must be set to Tach Start first. Next, turn the ignition on. (If your vehicle is a diesel, wait for the glow plug to go out then proceed to the next step) Start SAFETY FIRST! the engine with the key then press and release Button #4.
MECHANICAL NEUTRAL SAFETY SWITCH (Rear Wheel Drive Only) Entering Programming Mode When installing a Bulldog Security remote starter on GM vehicles or Dodge Make sure your key is not in the ignition and the brake is pressed. The brake is to remain Dakotas built prior to 1996, you must: Use the diagram below to create pressed as long as you want to remain in programming mode.
ANTENNA PLACEMENT CONNECTING DOORLOCKS WHEN ADDING 5-PIN DOORLOCK HARNESS Antenna DOORLOCK ACTUATORS Antenna Wire DOOR #1 CENTRAL LOCKING SYSTEM Control Module Run the antenna 4-pin harness up the windshield pillar on the driver’s side and across the top of the windshield tucking the antenna harness inside the headliner, behind the rearview mirror.
CONNECTING DOORLOCKS INSTALLATION DIAGRAM “Type C” Reverse Polarity (5-pin harness) POWER GREEN/BLACK Unlock Out DOOR security.com bulldog www. LOCK 800-878-8007 GREEN/WHITE Unlock In MOTOR RED 12 V CONSTANT Standards With Comply Tested 12V(+) Security Bulldog M200 WHITE/BLACK ACCESSORY RED/BLACK +12V Constant RED 12 V CONSTANT 12V(+) BLUE/BLACK Lock Out...
TESTING DOORLOCKS CONNECTING THE 18-PIN HARNESS Testing Switch Wire and Motor Wires 11. BLACK (-) Frame Ground for” Type C” Door Locks Attach to clean chassis ground. 12. RED/BLACK (-) F.A.S.D. (Factory Alarm Shut Down) Before connecting, you must now determine which wire is the switch wire This wire provides a negative output to disable the factory security system.
MAKING MAIN POWER, IGNITION AND ACCESSORY TESTING DOORLOCKS CONNECTIONS TO THE IGNITION SWITCH HARNESS There are four basic types or door locks: “Type A” Door Lock Test (Most GMs and some Chryslers) Probe both of your door lock wires going to the door lock switch usually located in the driver’s kick panel.