Advertisement
Introduction
The AL-100DP adds fully-featured antitheft function and protection to
your vehicle's existing factory-installed remote keyless entry system.
When armed, the AL-100DP can detect an unauthorized entry of the vehicle, and reacts
by sounding the horn and flashing the lights; when armed it will also prevent starting the
vehicle. The AL-100DP arms when you use your existing factory-equipped remote keyless
entry transmitter to lock your doors, and disarms when you use your transmitter to unlock
the doors.
Since the AL-100DP is a universal add-on security system for existing keyless entry
systems, its exact operations to some extent are determined by the particular vehicle and/or
keyless entry system to which it has been added. The AL-100DP has many programmable
features allowing personally customized operations, and there are also available options
such as electronic sirens and sensors, which can further enhance its operations.
Therefore this guide outlines typical operations of the system; you may wish to arrange
for a demonstration of your new AL-100DP security system. This guide describes the AL-
100DP operations only, and not any associated operations of the host vehicle or its remote
keyless entry system.
Your AL-100DP system has two principal user components: The Status Light informs
you at a glance which of the different conditions the security system is in, and also serves
as a visual deterrent to break-ins and theft. The Valet Switch is used to access Valet Mode,
which allows the operator to suspend some of the security system's normal functions
for as long as desired. The Valet Switch may also be used, if needed instead of the remote
keyless entry transmitter, to override an armed or activated AL-100DP.
Page - 2
Parking Light Override: This feature assists the installer, in how the AL-100DP is
configured in its connection to the vehicle, so that it is able to operate with the vehicle's
existing keyless entry system. The factory setting of this feature is off.
3rd Channel Activation: This feature allows you to choose how to activate the 3rd channel
operation IF used to activate an add-on accessory such as remote start. By default,
pressing LOCK, UNLOCK, then LOCK within 5 seconds will activate 3rd channel. You
can change this operation so 3rd channel activates by pressing LOCK twice within 5
seconds.
Anti-Carjacking protection can be activated by the ignition or by an open door. Each
method is programmable. You can utilize either or both. Once activated, you have 53
seconds to cancel the Anti-Carjacking by pressing the Valet Switchonce. If Anti-
Carjacking is not cancelled, 53 seconds after being activated the siren will begin to chirp
for 7 seconds to alert the user that the system is about to enter into an alarm
condition.
If the Anti-Carjacking process is not cancelled before 60 seconds passes, the system
will enter an alarm condition, sounding the siren and flashing the parking lights. 30
seconds after this occurs, or should the ignition be turned off in the meantime, the
starter interrupt will engage. Once the system enters the alarm condition, it can only be
disengaged by: Turn the ignition ON and press the valet switch once.
Page - 15
Advertisement
