9 Resetting to the initial state
The device can be reset to the initial state. Doing this deletes all
information relating to taught-in components.
To reset, proceed as follows:
• Press and hold down (for at least 3 seconds) the channel
button to switch the device to teach-in mode.
• The light flashes briefly. Press and hold down the channel
button again (for at least 3 seconds).
• The device LED flashes quickly to indicate that the actuator
has been reset to the initial state.
Resetting the device to the initial state only resets all
settings to the factory settings; it does not format the
microSDHC card.
10 Error codes and device LED feedback
Various actuator states and error codes are indicated by the
device LED flashing:
Flashing sequence
Slow red flashing
Fast red flashing
1x long red
3x short red
State
Teach-in mode
Reset
Error: When attempting to play back
an MP3, the device was not able to
read the memory card.
The file system of the memory card
must be formatted with FAT32 in
order to be used. Only MP3 and WAV
files can be read.
23