Introductions And Warnings - Hunter 30890 Owner's Manual

Congratulations! You've purchased one of the most advanced products available on
the market today to improve indoor air quality.
The Hunter Total Air Sanitizer captures most airborne pathogens "germs, viruses,
mold, and mildew" that enter the system. Hunter's patented technology then kills
virtually everything that has been captured within 24 hours of entering the system.
IMPORTANT SAFETY INSTRUCTIONS! READ AND SAVE ALL
INSTRUCTIONS BEFORE USING THIS AIR SANITIZER.
1. These service instructions are for use by qualified personnel only. To reduce the risk
of electric shock, DO NOT perform any servicing other than that contained in these
operating instructions.
2. This Total Air Sanitizer is designed for use on a flat, level floor and may not work properly
on an uneven floor. ALWAYS place the Air Sanitizer on a firm, level floor. ALWAYS place
the Total Air Sanitizer at least six (6) inches away from walls and heat sources such as
stoves, radiators, or heaters.
3. This Total Air Sanitizer is intended for indoor use only.
4. This Total Air Sanitizer is not intended for commercial or hospital use.
5. Place the Total Air Sanitizer in an area that is out of the reach of children.
6. Before using the Total Air Sanitizer, extend the cord and inspect for any signs of damage.
DO NOT use the product if the cord has been damaged.
7. Do not use this Total Air Sanitizer on a power strip. It is not recommended to use an
extension cord.
8. ALWAYS UNPLUG the Total Air Sanitizer while it is being cleaned. Wait 10 seconds
before opening the panel.
9. DO NOT move or tilt the Total Air Sanitizer while it is in operation. Turn off and
unplug before moving.
10. DO NOT immerse the Total Air Sanitizer in water at any time because permanent
damage will occur. To properly clean your Total Air Sanitizer, follow the instructions in
"Maintenance" on page 6.
11. To reduce the risk of electric shock, this product has a polarized plug (one blade is wider
than the other) as a safety feature. This plug will fit into any polarized outlet only one way.
If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. Do not attempt to defeat or override this safety feature.
12. This equipment should be inspected frequently and collected dirt removed from it regularly
to prevent excessive accumulation that could result in flashover.
3
At A Glance

Introductions and Warnings

WARNING! RISK OF ELECTRIC SHOCK
44068-01 • 11/11/2011
I