Table of Contents
Advertisement
Chapter 2
Chapter 2 Hardware
2-1 PC Assembly Instructions
1. Jumper Setting:
This motherboard is jumper free for CPU External Clock, Frequency Ratio and the
CPU voltage. These settings can be adjusted in the BIOS.
2. Installing FDD and IDE devices:
Aligned the red colored edge of the cable with the pin 1 of the drive connector on the
motherboard and attached it. Attach the other end of the cable by aligning the colored
edge to the pin 1 of the device connector. Make sure that all drives are securely
fastened.
3. Installing a CPU:
Locate a noticeable notch in the CPU's corner. This marking indicates Pin 1 of the
CPU. Gently insert the CPU with Pin 1 at the same corner of the socket that contains
the end of the lever.
4. Installing System Memory:
Push the module downward until the side clips click into place on the module.
7
Advertisement
Table of Contents
