Electrical Information; Intellifi Re Ignition System Wiring - Heat & Glo Dakota 42-B Owner's Manual

7 7

Electrical Information

A. Intellifi re Ignition System Wiring
• This appliance is equipped with an Intellifi re control valve
which operates on a 3 volt system.
• This appliance is supplied with a battery pack which is
located in the ON/OFF switch terminal box. A wiring
diagram is shown in Figure 7.1.
• The battery pack requires two D cell batteries (not
included). See Section 12.B. for battery replacement.
CAUTION
Battery polarity must be correct or module damage will
occur.
ON/OFF
WALL
SWITCH
IGNITION
MODULE
(3V)
LOW VOLTAGE
VALVE
Figure 7.1 Intellefi re Pilot Ignition (IPI) Wiring Diagram
14 Heat & Glo LifeStyle Collection • Dakota 42-B/Dakota 42H-B • 4036-909 • Rev J 11/08
BATTERY
PACK
FLAME SPARKER/
SENSOR
BATTERY
SEE NOTE 1
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous
operation. Verify proper operation after servicing.
IGNITION MODULE
3 VAC
PACK
RED
PIGGYBACK
ON/OFF SWITCH
WARNING
Shock Risk
• Replace damaged wire with type 105° C
rated wire.
• Wire must have high temperature
insulation.
CAUTION
I
S
WHT
ORG
GROUND TO
FIREPLACE
CHASSIS
VALVE
INTERMITTENT
PILOT
IGNITOR