Table of Contents
Advertisement
4-1. "P" HANDLE ASSEMBLY (MT3075)
1. To install handle onto unit, you will need the following
components from your user kit: "P" handle (A & B),
screws (C) and nuts (D). (Figure 4-1A).
2. Install the handle (B) on the shaft 160-200mm from
throttle and tighten the 2 screws (C) and nuts (D).
A
B
4-2. "J" HANDLE ASSEMBLY (MT3090/
MT30775/MT30790)
1. To install handle onto unit, you will need the following
components from your user kit: "J" handle (A), middle
clamp housing (B), upper and lower clamps (C) and
screws (D). (Fig. 4-2A)
2. Install the middle clamp housing (B) on the shaft near
the arrows on the sticker (warning label E ), put the low-
erclamp (C) under shaft and tighten with 2 screws (D).
3. Install the J handle (A) on the middle clamp housing,
then put the upper clamp (C) over J-handle and tighten
the other 2 screws (D).
E
C
B
C
4-3. BLADE GUARD INSTALLATION
(MT3075/MT30775)
1. Remove gear collar (A) from the threaded gear housing
shaft (Figure 4-3A).
2. Place the shield on the gear housing and align the
mounting holes. Insert screws (B), found in the hard-
ware bag as shown in illustration and tighten securely
(Figure 4-3B).
4 - ASSEMBLY INSTRUCTIONS
C
D
4-1A
D
A
D
4-2A
3. Reinstall the gear collar (A). Ensure the collar spacer
(C) is in place or the collar will rub the gear housing
(Figure 4-3A).
A
C
4-4. DEBRIS SHIELD (MT3090/MT30790)
1. Remove gear collar (A) from the threaded gear housing
shaft. Insure collor spacer (C) is in place (Figure 4-4A).
2. Install debris shield with 3 screws (B) provided in the
hardware bag. (Figure 4-4B)
A
C
4-3A
B
4-3B
4-4A
B
4-4B
6
Hide quick links:
Advertisement
Table of Contents
