Craftsman 919.672101 Owner's Manual page 12

BEFORE STARTING
Read and understand all Important
Safety Instructions in the front of
this manual and the following
Cautions and Warnings before
starting the pressure washer.
• Never fill fuel tank completely.
Fill tank to 1/2" below bottom of
filler neck to provide space for
fuel expansion. Wipe any fuel
spillage from engine and
equipment before starting
engine.
• Never fill fuel tank indoors.
Never fill fuel tank when engine
is running or hot. Do not smoke
when filling fuel tank.
• Never run engine indoors or in
enclosed, poorly ventilated
areas. Engine exhaust contains
carbon monoxide, an odorless
and deadly gas.
• Never turn water supply off
while pressure washer engine is
running or damage to pump will
result.
• DO NOT use hot water, use cold
water only.
• DO NOT stop spraying water for
more than two minutes at a
time.
NOTE: Remove and discard blue plug
in fuel fill.
1. In a well ventilated outdoor area
add fresh, high quality, unleaded
gasoline with a pump octane
rating of 86 or higher. Do not
overfill. Wipe up spilled fuel before
starting the engine.
D28236
2.
3.
4.
5.
6.
NOTE: Water source must provide a
minimum of 5 gallons per minute at
20 p.s.i.
Fuel
Fill
12- ENG
Remove filler cap/dipstick and
add engine oil (supplied) to
engine. NOTE: There will be a
slight amount of oil in the engine
from factory testing. Always check
oil level before each start-up.
Oil level should be at the FULL
line on dipstick. Always check oil
level before each start-up.
Verify the filter screen is in water
inlet of pump. NOTE: Cone side
faces out.
Filter Screen
Connect high pressure hose to
pump outlet.
Connect water source to pump
inlet.
High
Water
Pressure
Source
Hose
Filler cap/
dipstick