Advertisement
manual2_ A5 _Engl.
26.09.2003
16:29 Uhr
OWNER MANUAL
1.
Mount the front derailleur on the seat tube
(without chain) and turn it in a temporary position,
2.
Check that the chain guide does not protrude
beyond the largest chain wheel by more than
2 mm. The chain guide must not touch the chain
wheels
3.
The chain guide must run parallel to the chain
wheels. Check above,
4.
Tighten the frame bolt and change to the smallest
gear (smallest chain wheel, larger rear sprocket).
In this position, the chain must almost run against
the chain guide inner blade,
5.
Tighten the front derailleur control cable and
secure with the pinch bolt,
6.
Change to the highest gear (largest chain wheel,
smallest sprocket). In this position the chain must
almost run against the chain guide outer plate of
the right pedal crank,
7.
Adjust both highest positions of the front
derailleur with the adjusting screws,
Seite 8
8.
Change the chain to the smallest and the largest
gear. In both gears, the front derailleur must
smoothly and immediately change the chain from
the smallest to the largest chain wheel and vice
versa.
Note: This procedure applies for both two and three-
ringed pedal cranks with round chain wheel.
Caution!
To avoid excessive wear and damage of the chain,
sprockets and chain wheels, we advise against the fol-
lowing combinations (see illustrations):
Largest chain wheel – largest sprocket
Smallest chain wheel – smallest sprocket
Regularly check that your chain is clean and well-lubri-
cated. Have your dealer check the chain for wear.
Should you nevertheless want to check it yourself, you
need to purchase the Rohloff Chain Caliber 2 from your
SCOTT Dealer. This caliber will help you to work out
whether your chain is too slack of not.
Caution!
Do not press both right hand change control levers or
both left hand change control levers at the same time.
Damage to the change control may result.
Rear lever Operation
For both lever A and lever B, the lever always returns to
the initial position when it is released after changing.
To change from a small sprocket to a larger
sprocket
To change one gear step, press lever A to position 1; to
change two, three or four gear steps at one time, press
lever A to position 2, 3 or 4 respectively. A maximum of
four step change can be operated in this manner.
To change from a larger sprocket to a smaller
sprocket
When lever B is pulled once and is then released, there
is one step change from a large gear to a smaller gear.
Lever (B)
7
2
Lever (A) starting
1
position
Advertisement
