Changing The Maximum Station Number - Hunter Residential/Light Commercial Remote Control System Owner's Manual And Installation Instructions

CHanGinG THe MaXiMuM sTaTion nuMbeR .........................

Your ROAM Transmitter comes from the factory with
the maximum station number set to 15. This means
that when you use the
change the station, you may change it to any number
between 1 and 240. However, if you only have a
6-station controller, you will never need to access
stations 7 through 9. Likewise, perhaps you will
own a Hunter controller like the ICC which can have
more than 9 stations. In this case you would want to
access the stations above 9.
Caution: If MAX station is set to 240, ROAM will
only work with the ACC controller. If you are using
an SRC, Pro-C, or ICC controller, make sure your
station count is set to 1 - 48.
The ROAM Transmitter allows you to set the
maximum station number as follows:
1. If the unit is off (no display), power the
Transmitter up by pressing any of the buttons for
at least 1 second then releasing the button. The
Transmitter will display the active station.
and buttons to
2. Press the Mode button until the Station Number
icon is displayed.
3. Use the and
maximum station number from 1 to 240. Then,
do not press any buttons for 10 seconds and the
display will return to the active station number
4. You may now change the active setting to any
station in the new station range.
buttons to change the
15