Changing The Transmitter Address - Hunter Residential/Light Commercial Remote Control System Owner's Manual And Installation Instructions

CHanGinG THe TRansMiTTeR addRess ..................................

Both the ROAM Transmitter and Receiver have an
"address" that they use when communicating. If the
addresses do not match, the receiver will ignore the
transmission.
Your ROAM comes from the factory with both the
Transmitter and the Receiver address set to 1. You
may change the address to any value from 0 through
127 for added security. Note that if you change the
Transmitter address, the Receiver must "learn" the
new address as described in "Preparing the Receiver
for Use" section.
To change the Transmitter address follow the
steps below:
1. If the unit is off (no display), power the
Transmitter up by pressing any of the buttons for
at least 1 second then releasing the button. The
Transmitter will display the active station.
14
2. Press the Mode button until the Address Key
icon is displayed.
3. Use the and
address to any value between 0 and 127. Then
do not touch any of the buttons for 10 seconds
and the display will return back to the active
station.
buttons to change the