Roland M-480 Owner's Manual page 61

For details, refer to "Limiter operations" (p. 80).
3 Insert indication
fig.ScrChInsOut.eps
3
FX INS
1
If FX1–6 are inserted, the number of the inserted FX is shown
here.
If the number is shown in white, the effect insertion is
enabled. If it is shown in gray, effect insertion is bypassed.
By moving the cursor to FX INS and press [ENTER], you can
access the FX 1–6 tab of the EFFECTS.
Inserting an effect into a channel is done in the EFFECTS screen.
For details, refer to "Inserting an effect into a channel" (p. 101).
Up to six effects can be inserted into one channel. In this case,
they will be inserted in series, in order of the FX number.
GEQ INS
2
If a GEQ is inserted, this shows the number of the GEQ that is
inserted.
If the number is shown in white, the inserted GEQ is enabled.
If it is shown in gray, the inserted GEQ is bypassed.
By moving the cursor to GEQ INS and pressing [ENTER], you
can access the GEQ 1–6 tab or GEQ 7–12 tab of the EFFECTS
screen.
Inserting a GEQ is done in the EFFECTS screen. For details, refer
to "Inserting the GEQ" (p. 105).
EXT FX
3
If an external effects processor is inserted, this shows the
number of the inserted EXT FX.
By moving the cursor to EXT FX and pressing [ENTER], you
can access the EXT FX 1–6 tab or EXT FX 7–8 tab of the
EFFECTS screen.
Inserting an external effects processor into a channel is done in
the EXTERNAL INSERT screen. For details, refer to "Inserting an
EXT FX into a channel" (p. 111).
AUX, MTX, MAIN operations
4 4-band EQ
fig.ScrChEQ.eps
1
2
4
5
6
7
EQ button
1
This turns the 4-band EQ on/off.
4-band EQ graph
2
This shows the approximate response of the 4-band EQ.
OL (Overload) indicator
3
This will light when the output of the 4-band EQ exceeds the
OVER Lev setting specified in the METER SETUP popup (p.
96).
Type
4
These select the filter type from the following choices:
Type Function
LSV Low shelving
HPF1 -6 dB/oct high-pass filter
HPF2 -12 dB/oct high-pass filter
PEAK Peaking
BPF Band-pass filter
NOTCH Notch filter
HSV High shelving
LPF1 -6 dB/oct low-pass filter
LPF2 -12 dB/oct low-pass filter
Q knobs
5
This adjusts the Q in a range of 0.36–16.00. Higher values
produce a sharper curve.
This is not shown when LSV, HPF1, HSV, or LPF1 is selected as
the filter type.
FREQ knobs
6
This adjusts the frequency in a range of 20 Hz–20.0 kHz.
GAIN knobs
7
This adjusts the gain in a range of -15.0 dB–+15.0 dB.
This is not shown when HPF1, HPF2, BPF, NOTCH, LPF1, or LPF2
is selected as the filter type.
For details, refer to "4-band EQ" (p. 82).
3
Desc.
LO only
HI only
61