Fujitsu SPARC Enterprise T1000 Getting Started Manual page 2

Set aside sufficient time – Installation times vary, but if you are performing these setup instructions for the
■
first time, plan to spend about 45 to 75 minutes to complete all of these instructions. Additional time might be
required for installing optional hardware and rackmounting kits.
Obtain a terminal device – You configure this rackmountable server through the SC using the built-in serial
■
management and network management ports, and not through a graphical interface and keyboard. To
communicate with the SC, you will need a terminal device, which can be a terminal, terminal server, or laptop
running terminal emulation software.
Gather your configuration information – During the configuration, you are prompted for time zone and
■
networking parameters for your environment. Use
Configuration Information
TABLE 1
Parameter Description
Language Select a number from the displayed language list.
Locale Select a number from the displayed locale list.
Terminal Type Select a terminal type that corresponds with your terminal device.
Select Yes.
Network?
Multiple Network Select the network interfaces that you plan to configure. If you are not sure,
Interfaces select the first one in the list.
DHCP? Select Yes or No according to your network environment.
Host Name Enter the host name for the server.
Enter the IP address for the selected Ethernet interfaces.
IP Address
Subnet? Select Yes or No according to your network environment.
Subnet Netmask (If subnet was Yes) Enter the netmask for the subnet for your network
environment.
IPv6? Specify whether or not to use IPv6. If you are not sure, select No to
configure the Ethernet interface for IPv4.
Select either standard UNIX security (No) or Kerberos Security (Yes). If you
Security Policy
are not sure, select No.
Confirm Review the onscreen information and change it if needed. Otherwise,
continue.
Name Service Select the name service according to your network environment.
Note – If you select a name service other than None, you will be prompted
for additional name service configuration information.
NFSv4 Domain Select the type of domain name configuration according to your
Name environment. If you are not sure, select Use the NFSv4 domain derived
by the system.
Time Zone Select your continent.
(Continent)
Select your country or region.
Time Zone
(Country or Region)
Time Zone Select the time zone.
Date and Time Accept the default date and time, or change the values.
root Password Enter the root password twice. This password is for the superuser account
for the Solaris OS on this server. This password is not the SC password.
to record your configuration information.
TABLE 1
Your Entry