How To Connect Using A Single Amplifier - McIntosh XR100 Owner's Manual

Table of Contents

Spade Lug or Wire Connections:

10. Referring to the illustration connect the Loud-

speaker hookup cables to the XR100 Negative (-)

Input Terminal and Positive (+) Input Terminal.

Insert the spade lug connector or prepared section

of the cable end into the Input Terminal side access

hole, and tighten the Input Terminal cap until the

cable is firmly clamped into the terminals so the

lugs or wire cannot slip out. Refer to figures 15

and 16.

Note: It is important to maintain the correct polar-

ity at both ends of the Loudspeaker cables.

Figure 15

11. Connect the other end of Loudspeaker cables

coming from the XR100 Negative (-) LOW Input

Terminal to the Left Channel COM (-) 8 Ω Output

Terminal of the Amplifier.

12. In a similar manner, connect the Loudspeaker

cables coming from the second XR100 Positive (+)

LOW Input Terminal to the Left Channel 8 Ω (+)

Output Terminal of the Amplifier.

13. Connect the second XR100 Loudspeaker in a

similar manner to the Amplifiers Right Channel

Terminals.

XR100

Right Channel

Figure 16

Jumper