Installing a diskette drive or card reader in bay 3
To install a diskette drive or card reader in bay 3:
1. Open the computer cover. See "Opening the cover" on page 12.
2. Remove the front bezel . See "Removing the front bezel" on page 14.
3. Remove the plastic panel in the bezel by squeezing the plastic tabs that secure
4. Slide the diskette drive to the locked position. See "Locating internal
Figure 11. Installing a new drive
5. Connect the flat cable to the new drive.
6. Reinstall the front bezel.
22
ThinkStation Hardware Installation and Replacement Guide
the panel on the inside of the bezel.
Note: On the inside of the front bezel where the drive is to be located there is a
drive adapter plate for each drive. Remove the drive adapter plate and use it to
install the drive.
components" on page 8.
What to do next:
v To work with another option, go to the appropriate section.
v To complete the installation, go to Chapter 4, "Completing the parts
replacement," on page 43.