Ford Explorer 2008 Owner's Manual page 114

Driver Controls
HomeLink should now activate your rolling code equipped device. To
program additional HomeLink buttons begin with Step 1 in the
"Programming" section. For questions or comments, please contact
HomeLink at www.homelink.com or 1–800–355–3515.
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink to accept the signal
from the hand-held transmitter.
After completing Step 1 outlined in
the "Programming" section,
replace Step 2 with the following:
Note: If programming a garage door
opener or gate operator, it is advised to unplug the device during the
"cycling" process to prevent overheating.
• Continue to press and hold the HomeLink button (note Step 2 in the
"Programming" section) while you press and release — every two
seconds ("cycle") your hand-held transmitter until the frequency
signal has been accepted by the HomeLink . The indicator light will
flash slowly and then rapidly after HomeLink accepts the radio
frequency signal.
• Proceed with Step 3 in the "Programming" section.
Operating the HomeLink Wireless Control System
To operate, simply press and release
the appropriate HomeLink button.
Activation will now occur for the
trained product (garage door, gate
operator, security system, entry
door lock, or home or office lighting
etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time. In the
event that there are still
programming difficulties, contact
HomeLink at www.homelink.com or 1–800–355–3515.
114
2008 Explorer (exp)
Owners Guide (post-2002-fmt)
USA (fus)