HP Compaq dx2700 Microtower and Small Form Factor Overview page 10

QuickSpecs
System Details
Power Supply Power Supply Power Supply Power Supply
Power Conservation Power Conservation Power Conservation Power Conservation
'Energy Saver' 'Energy Saver' 'Energy Saver' 'Energy Saver'
System Environmental System Environmental System Environmental System Environmental
Specs Specs Specs Specs
ATX Power Supply – Passive PFC at 230V only/non-PFC with a 115v/230V line switch
Passive Power Factor Correction (PFC) – with voltage set to 230V
50–60 Hz rated line frequency
250 watt as default power output for both MT and SFF
MT has maximum 300W non-PFC power supply to migrate for non-China regions only.
SFF form factor doesn't have 300W to upgrade.
Energy Star compliant
APM 1.2 support
Screen blanking
Hard drive 'Idle' mode
System Idle mode
CCEC – China Only (<3 w in S5 – power off)
<10 watt power consumption in Sleep mode – suspend to RAM (S3) (instantly available PC)
Processor/Cache memory power-down (S3)
Default waiting time no less than 30 minutes prior to entering sleep mode
Values are subject to change without notification and are for reference only.
Performance of system, options, and ancillary equipment will vary depending on the system
configuration.
Levels presented do not account for non-HP/Compaq installed hardware.
Ambient Air Temperature Ambient Air Temperature Operating Ambient Air Temperature Ambient Air Temperature
Humidity Humidity Humidity Humidity
Altitude Altitude Altitude Altitude
Shock Shock Shock Shock
DA - 12661 Worldwide — Version 1 — March 21, 2007
HP Compaq dx2700 Microtower and Small Form Factor HP Compaq dx2700 Microtower and Small Form Factor HP Compaq dx2700 Microtower and Small Form Factor HP Compaq dx2700 Microtower and Small Form Factor
Operating Operating Operating
Storage Storage Storage Storage
Operating Operating Operating Operating
Storage Storage Storage Storage
Operating Operating Operating Operating
Non-Operating Non-Operating Non-Operating Non-Operating
Listed are the levels of shock the product can withstand with NO damage
being incurred. The values represent peak input acceleration during an 2~3
ms half-sine shock pulse
Non-Operating Non-Operating Non-Operating Non-Operating
5° to 40°C at sea level with an altitude de-rating
of 1.0°C per every 1000 ft (300 m) above sea
level to a maximum of 8,000 ft (2500 m), no
direct sustained sunlight. Maximum rate of
change is 25°C/Hr. The upper limit may be
limited by the type and number of options
installed.
-30° to 60°C –
Maximum rate of change: 210°C/Hr.
10% to 90% relative humidity (Rh), 30°C
maximum wet bulb temperature, non-condensing
10% to 95% relative humidity (Rh), 38.7°C
maximum wet bulb temperature, non-condensing
0 to 8,000 feet (0 to 2438.4 meters) – This value
may be limited by the type and number of
options installed. Maximum allowable altitude
change rate is 1,000 ft/min (304.8 m/min).
0 to 30,000 feet (0 to 9,144 meters) – Maximum
allowable altitude change rate is 1200 ft/min
(365.76 m/min).
35G's (Half-sine Shock)
35G's (Trapezoidal Shock)
Business PC Business PC Business PC Business PC
Page 10