Table of Contents
Advertisement
•
Confi rm the new IP Address by looking on the front
panel display of the TGM-HDC. It should now display
the value that you just added.
•
Type the new IP Address into the web browser. You
may be prompted to restart the browser before typing
in the new address.
•
You have now confi gured a
TGM-HDC.
Mail
This section describes how to set up mail preferences in
order to receive email notices of system errors and warn-
ings. Error messages may be sent to the user, the installer,
and to Sunfi re Technical Support staff in order to increase
reliability and deal with issues preemptively as they may
arise.
•
Click on
Mail.
•
Enter the
Mail-from address:
xxxxxxxx_customerlastname@dealername.tgm
The "xxxxxxxx" represents the last eight digits of the
TGM-100s serial number. There are up to 40 total charac-
ters available.
•
Enter up to three email addresses into the sections
labelled Mail-to address 1:, Mail-to address 2:, and
Mail-to address 3:. It is recommended to enter the
owner's email into fi eld 1, the installer's email into fi eld
2, and Sunfi re's email into fi eld 3. Sunfi re's diagnostic
email is: tgmhdc@sunfi re.com.
•
Select which events you want to be sent to each
address. Typically WARNING and ERROR will be
selected. For the "Sunfi re" email, select ERROR only.
•
Click
Confi rm to set these values.
Installation Manual
Static IP Address for the
iSCSI Confi g
This section describes how to confi gure settings that the
TGM-HDC uses to sommunicate with the TGM-100.
•
Click on
iSCSI confi g.
•
Click on
NIC.
•
On the
LAN1 line, change DHCP to No.
•
Enter a new
IP address that is within the range of IP
addresses reserved for this task. Do not enter an IP
address that is within the DHCP server's range. The
example below uses 192.168.0.201.
•
The other values in this area will typically not be
changed.
•
Click
Aggregation to set the new values.
Enclosure Management-UPS
This section describes how to confi gure settings for the
Uninterruptible Power Supply required for use with the
TGM-HDC and TGM-100. These settings are suggestions
and each installation may vary.
•
Click
Enclosure management.
•
Click
UPS.
•
Under
UPS type:, select Smart-UPS.
•
Under
Shutdown battery level (%), select 10. This
will cause the UPS to power down the TGM-HDC and
TGM-100 when the UPS' battery reaches 5% capacity.
•
Under
Shutdown delay (s):, select 180. This will
provide three minutes to shut down the TGM-HDC/
TGM-100 once the low battery condition of the UPS is
reached.
CHAPTER 3
31
Advertisement
Table of Contents
