Table of Contents
Advertisement
CHAPTER 3
•
Select
TGM-100C Clients. All available TGM-100C
Clients should be listed.
•
If the TGM-100 Server has not detected any TGM-
100C Clients, press ä Refresh to re-scan the
network.
•
Select each TGM-100C Client and press
connect it to the TGM-100 Server.
•
Press
M Save.
•
To disconnect a TGM-100C Client, select the unit from
the list and press O Release.
External Storage
Whichever external storage device you choose, it must
be connected to a TGM-100 Server (not a client). You can
use both an eSATA or a TGM-HDC iSCSI external storage
device. Multi-volume support, when implemented, will be
available via the online upgrade facility. Plug the eSATA
drive into the eSATA socket on the back of the TGM-100
Server only.
Connecting eSATA Storage: TGM-HD1 (1Tb)
•
With all units powered Off, plug the TGM-HD1 into the
eSATA port on the back of the TGM-100 and power it
up.
•
Power up the TGM-100. The TGM-HD1 should
be detected by the TGM-100 during startup and
automatically be available for immediate use.
•
It may be necessary to reboot the TGM-100 the fi rst
time a TGMHD1 is connected.
•
Should the TGM-100 detect any inconsistency in the
TGM-HD1 setup during startup, it will correct this
automatically and then restart itself, using the new
confi guration.
30
Connecting Ethernet Storage: TGM-HDC
This section covers the basic information needed to get
the Sunfi re TGM-HDC connected and functioning with the
TGM-100.
•
Connect the TGM-HDC device as described previously.
•
Connect a PC to the network and start your browser.
•
Turn on the UPS and the 3 power switches on the back
of the TGM-HDC. The unit will output an audible signal
once startup has completed.
Your TGM-HDC external storage device must be powered
using an Uninterruptible Power Supply (UPS).
IP Address
•
Write down the IP Address of the TGM-HDC that
appears in the window on the front of the unit. For
example: 192.168.000.198.
•
Open a web browser from the PC and enter the TGM-
O Control to
HDC's IP Address. The Confi guration Screen will
appear.
•
Click on
parameters available to set up the TGM-100. The User
name/Password dialog box will appear.
•
Enter the user name:
•
Enter the password:
•
Click on
Change this to Static.
•
Enter a new IP Address that is in the range of your
network. The example below uses 192.168.000.250.
•
Click
System confi g for an overview of all the
admin
.
en91n3
.
IP address. The default setting is DHCP.
Confi rm to change the IP Address.
Installation Manual
Advertisement
Table of Contents
