Engine Coolant Check - Ford Kuga Owner's Handbook Manual

Topping up
WARNINGS
Only top up when the engine is cold.
If the engine is hot, wait 10 minutes
for the engine to cool down.
Do not remove the filler cap when
the engine is running.
Remove the filler cap.
CAUTION
Do not top up further than the MAX
mark.
Top up with fluid that meets the Ford
specification. See Technical
specifications (page 150).

ENGINE COOLANT CHECK

Checking the coolant level
WARNING
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse
the affected areas immediately with
plenty of water and contact your doctor.
CAUTION
Make sure that the level is between
the MIN and the MAX marks.
Note: Coolant expands when it is hot.
The level may therefore extend beyond
the MAX mark.
If the level is at the MIN mark, top up
immediately.
Maintenance
Topping up
In an emergency, you can add just
water to the cooling system to reach
a vehicle service station. The system
must then be drained and refilled with a
50/50 mixture of coolant and water. Have
the system checked by a properly trained
technician as soon as possible.
Increased dilution of the coolant can
cause engine damage from
corrosion, overheating or freezing.
Unscrew the cap slowly. Any pressure
will escape slowly as you unscrew the
cap.
Do not top up further than the MAX
mark.
Top up with a 50/50 mixture of coolant
and water using fluid that meets the Ford
specification. See Technical
specifications (page 150).
148
WARNINGS
Only top up when the engine is cold.
If the engine is hot, wait 10 minutes
for the engine to cool down.
Do not remove the filler cap when
the engine is running.
Do not remove the filler cap when
the engine is hot. Wait for the engine
to cool down.
Undiluted coolant is flammable and
may ignite if spilt on a hot exhaust.
CAUTIONS
CAUTION