Table of Contents
Advertisement
OPERATION
Prepare
Plug appliance into a suitable
7
mains supply. The straightener
is ready for use. There is no
need to preheat the straight-
ener.
Always place straightener on a
7
solid, flat, heat resistant surface.
Do not place straightener on
any soft or uneven surfaces such
as carpets, bedding or rugs.
Never cover the unit.
The plates heat up to a high
temperature (200°C) quickly.
Straighteninghair
1
Switch the appliance ON using
switch
C
.
– Power on indicator
nates.
2
Separate a section of hair
approximately 5 cm in width
and smooth it out with a brush.
Start with the neck.
3
Place the section of hair bet-
ween the plates
straightener as near to the hair
line as you can and close the
plates. Take care not to touch
the hot plates.
________________________________________
illumi-
B
of the
A
4
Hold the straightener in place
until the hair is fully heated.
This will be almost instant.
5
Once the hair is heated, hold-
ing the hair taut, carefully slide
the plates
A
of hair, in one smooth move-
ment all the way down to the
ends.
Notes:
If you have thick hair, you might
7
have to repeat this process on
the same section several times.
Keep the strands of hair smooth
7
to avoid ridges.
Repeat the procedure section by
7
section.
6
Repeat this procedure with steps
2 to 5.
7
After
using
switch off the appliance using
switch
C
and disconnect the
power cord from the mains.
– Power on indicator
pears.
along the section
the
appliance,
disap-
B
ENGLISH
1 7
Advertisement
Table of Contents
