Fine Tuning Your St9400S; Changing From Am/Pm Time Display To The 24-Hour Clock; Changing The Installer Parameters - Honeywell ST9400S User Manual

FINE TUNING YOUR ST9400S

Changing from AM/PM Time Display to the 24 Hour Clock
Your ST9400S can operate on the 12 hour AM/PM or 24 hour clock formats. To
change the format, ensure the slider is in the RUN position then press and hold the
and buttons together for about 2 seconds. Ignore the 'NOT VALID' message
that will appear briefly. All the displayed times will be automatically changed to the
new format.
Repeating this procedure will change the clock display back to the original format.

Changing the Installer Parameters

The ST9400S has a special Installer Mode where some features can be adjusted
to suit your lifestyle or preferences – these are called Installer Parameters, and are
listed in the table below, along with a description of the options that are possible.
INSTALLER
PARAMETER
24hr or am/pm
clock display.
Configure backlight
operation.
Enable/disable auto
time change.
Number of ON/OFFs
per day.
Select default time
programme.
Reset all parameters
12
Parameter Default
Number Value
1 12
2 2
3 1
5 2
6 A
8 1
Options Description
12, 24 12 = am/pm display,
24 = 24hr display
0, 1, 2 0 = off,
1 = on if button pressed,
2 = on continuously
0, 1 0 = disabled,
1 = enabled
2, 3 2 = 2 on/offs per day,
3 = 3 on/offs per day
A, b, C A = standard,
b = at home,
C = economy
0, 1 0 = do not reset
1 = default parameters