Advertisement
29697_WR-5000_IB
8/25/06
3:57 PM
Product Features
Shaver Parts
(A) Head & cutter assembly
(B) ON/OFF button
(C) Power port (Rear)
(D) Head guard
(E) Cleaning brush
(F) Power adapter
(D)
(E)
(F)
4
Page 4
(A)
(B)
(C)
How to Use
Please refer to your Safety Instructions
before operating your shaver.
Removing the Headguard
Before operating your shaver, remove the
headguard, which protects the screen and
cutter assembly. It is important to remove
the headguard correctly to avoid damag-
ing the clips that hold it to the shaver.
1. Lift the lower edges.
2. Pull the headguard away from the
shaver.
! Always keep the protective head guard
on the shaver head when the shaver is
not in use.
To Charge
Before using your shaver for the first time,
charge it for 24 hours.
Slide the ON/OFF button to the OFF
position.
Connect the cord to the shaver and
then to the electrical outlet. The
Charging Indicator light will glow
green, indicating your shaver is
charging.
Your shaver cannot be overcharged,
so you can leave it plugged in and
charging between shaves.
Use only the supplied cord.
The WR-5000 is designed for cordless
operation only. Plugging in the cord will
not provide the power to shave.
The WR-5000 fully recharges in 16 hours.
Once fully charged, your shaver will run
up to 40 minutes per charge.
ON/OFF SWITCH
To activate the shaver, slide the ON
switch up.
Charging Your Shaver
1. Your shaver may come with some
power, however it is best to charge
your shaver overnight before using.
2. This shaver can only be used cordless,
do not have shaver plugged into outlet
while shaving.
3. It may take up to 3 cycles for the
battery to reach full capacity.
5
Advertisement
