Page 1
“An ounce of prevention...,” and all that. The MQ 302L is a stereo equalizer, so adjusting any slider affects both channels simultaneously. Begin by setting all sliders to their center detent (0 dB), and the INPUT LEVEL to its center detent (0 dB).
INPUT LEVEL control and indicators This controls the overall level. 0 dB gain is reached at the center detent with all sliders Filter level slide controls centered at their 0 dB detents. Set the INPUT LEVEL to give equal volumes with the EQ Each of these sliders control the output level switched to ACTIVE or BYPASS, after setting the sliders (see EQ BYPASS switch below).
POWER switch and LED LEFT & RIGHT INPUTS Your basic, straightforward power switch. Choose between the balanced XLR or the When the yellow LED is lit, the MQ 302L is balanced/unbalanced ¼" TRS jacks, but ready to go. LEFT & RIGHT OUTPUTS only use one.
Be careful though, not to introduce too Mixers, mixer/preamps and the like often provide send/ much boost to the bass area. Be aware that the MQ 302L is receive loops for additional effects or EQ, and the MQ 302L capable of boosting signals up to 12 dB (4 times as large!)—a...
Page 5
the type of music and your audience. Fatten the bass, sweeten the highs, brighten the mids. Since you are starting from a “tuned” system, your ear will not be fooled into thinking bass is too high when actually mids are too low, or that highs are too weak when really the mids are too strong.
– though this complete note, call or email the factory, download it from assumes the interconnected equipment is internally grounded Rane's web site (http://www.rane.com) , or ask your dealer for properly. Since most equipment is not internally grounded a copy.
Page 7
VARIOUS XLR & ¼" CABLE ASSEMBLIES Manual-7...