Table of Contents
Advertisement
Security TFT-LCD Monitor USER'S MANUAL
MOUNTING GUIDE
Install Guide of wall mount bracket(STB-LM)
1) Make 4 holes in the wall using the bracket as a template, as below picture, and fix the bracket to the wall.
2) Fit the monitor bracket onto the rear of the monitor.
3) Finally, fit the two brackets together.
D-SUB CONNECTOR PIN ASSIGNMENTS
• PIN ASSIGNMENTS
Pin 1
RED VIDEO
Pin 9
Pin 2
GREEN VIDEO
Pin10
SIGNAL CABLE DETECT
Pin 3
BLUE VIDEO
Pin 11
GROUND
Pin 4
GROUND
Pin 12
SDA(for DDC)
Pin 5
GROUND
Pin 13
H-SYNC.(or H+V SYNC.)
Pin 6
RED GROUND
Pin 14
V-SYNC
Pin 7
GREEN GROUND
Pin 15
SCL(for DDC)
Pin 8
BLUE GROUND
• ACCESSORY
1. POWER CORD
2. USER'S MANUAL
5. Remote Control
6. Batteries
Wall
Pad
Arm
Monitor
D-SUB
3. PC cable
4. Adaptor
7. Wall mount (Option)
8. Rack mount (Option)
14
Security TFT-LCD Monitor USER'S MANUAL
POWER MANAGEMENT
This monitor features a power management system to "power down" upon receipt of the VESA DPMS (The display
power management signaling) from a VESA DPMS video card. The VESA DPMS-compliant video card performs this
signaling system through not sending horizontal, vertical, or sync signal. This monitor enters an appropriate mode
through identifying each of the three modes of the signaling system.
• POWER CONSUMPTION
MODE
POWER CONSUMPTION
ON
< 42W
STANDBY
< 3W
• LED INDICATOR
The power management feature of the monitor is comprised of four stages : On(Green), Standby, Suspend, Active
off(Amber) and Unsupported mode(Green).
MODE
LED COLOR
ON
GREEN
Normal Operation
STANDBY
Screen blanks after preset idle time And some electronic circuits or all
SUSPEND
AMBER
Circuitry in the monitor shut down.
ACTIV OFF
UNSUPPORTES
GREEN
Normal operation but the on screen Display will show error massage
MODE
POWER OFF
RED
Not Operation
TROUBLESHOOTING GUIDE
TROUBLE
1. Check that power cord of the monitor have been connected securely
into wall outlet or grounded extension cable or strip.
No image on display screen
2. Power switch should be in the ON position and LED is lit.
3. Check that the Brightness and / or the Contrast adjustments of the Display
haver not been turned down to minimum levels.
1. The signal cable should be completely connected to the video card /
"Check Input Signal" message
computer
on screen
2. The video card should be completely seated in its slot and the computer is
switched ON.
Display image is not centered, too
Push the down key in front side or Auto key in remocon.
small or toolarge in PC mode
Vertical or Horizontal noise is
Adjust Clock and Phase in the OSD.
present in the picture
MODE
POWER CONSUMPTION
SUSPEND
< 3W
ACTIVE OFF
< 3W
MONITOR OPERATION
TROUBLESHOOTING TIP
15
Advertisement
Table of Contents
