Panasonic Wedeatsu Wave EP1272 Operating Instructions Manual page 14

4. Adjusting shoulder position
• When a pre-program begins, the backrest and legrest automatically move the massage position where the
massage heads carry out a Soft Shiatsu massage in the area around the shoulders. During the time that the
shoulder position indicator is flashing (approx. 7 seconds), use the Neck Roller Position button to align the
position of the massage heads to your shoulder height.
Approximate positions for adjusting the position of the heads are shown below.
Up
Press
• 5-stage adjustment
Helpful Tips
Too high
Correct position
• Lightly touching
the shoulder.
Too low
• Persons whose height is less than 4.6 ft. (140 cm) or more than 6.1 ft. (185 cm) are recommended to use the
chair in the manner described below when the massage heads do not touch their shoulders.
When height is around 4.6 ft. (140 cm) or less
Use by placing a cushion on the seat and
sitting as far back as possible.
5. Selecting an area for a focused massage
• Please see pages 14–17 for details regarding manual operation.
Massaging the Neck and Shoulders
Press
• Press this button to focus the massage on the neck
and shoulders. (The upper and lower back will also
be massaged slightly.)
• Press the button again to toggle it off.
12
Down Approximate Height
6'1" (185 cm)
5'2" (160 cm)
Press
4'6" (140 cm)
• When the shoulder position indicator is flashing, adjust the position of
the massage heads (upper heads) so that they lightly touch the
shoulders.
• The shoulder position can be adjusted up and down 4 in. (10 cm).
• When it is not possible to correctly adjust the shoulder position, you
may have to slide your body and adjust it again.
• It is possible to change the position of
the massage heads during the massage.
When height is around 6.1 ft. (185 cm) or more
Use by reclining the backrest and
sliding your body downward.
Massaging the Lower Back
• Press this button to focus the program on the lower
back. (The neck and shoulders will also be
massaged slightly.)
• Press the button again to toggle it off.
Press