Rear Panel - Hawking 100M User Manual

Wiring for 10/100/1000Mbps (Copper)
Below is the summary of the cabling required:
LED Definition
The rich diagnostic LEDs on the front panel help display the operating status of individual ports as well as the entire
system.
Power LED
This indicator is lit green when the switch is receiving power; otherwise, it is off.
Port LEDs
Every RJ-45 port on the front panel has two LEDs (10/100M, 1000Mbps) for indicating the connection speed and activity
status.
Port LED Summary Table:
If the port is connected but the Port LED is dark, check the following items:
If the switch's and the connected device's power are on or not
If the connecting cable is good and of the correct type
If the cable is firmly seated in its connectors in the switch and in the associated device
If the connecting device, including any network adapter, is well installed and functioning properly

1.5 Rear Panel

Media
10/100/1000Mbps copper
LEDs Status
Steady /Blinking Amber Connected as 10Mbps/Active
10/100M
Steady/Blinking green
1000M Steady/Blinking green
Speed Wiring
10Mbps Category 3,4,5 UTP/STP
100Mbps Category 5 UTP/STP
1000Mbps Category 5,5e UTP/STP
Statement
Connected as 100Mbps/Active
Connected as 1000Mbps/Active
7