Starting And Stopping; Starting Engine - Husqvarna 425 BVS Operator's Manual

Starting and stopping

WARNING! Always move the machine
!
away from the refuelling area and source
before starting. Place the machine on a
flat surface.
Make sure no unauthorised persons are
in the working area. Otherwise there is a
risk of serious personal injury. The safety
distance is 15 metres.
The machine may only be started in its
complete design. If the machine is
started without all the guards fitted there
is a risk of personal injuries.

Starting engine

Pump the primer until fuel flows out in the clear tube.
Move the choke lever upward to choke position.
1 Choke lever
2 Choke lever in "closed position".
3 Choke lever in "open position".
Holding the blower handle, pull the starter rope with your
right hand. (throttle trigger in idling position).
NOTE!
Do not pull the starter cord all the way out and do not let
go of the starter handle when the cord is fully extended.
This can damage the machine.
After the engine starts, slowly open the choke. Allow the
engine to warm for a few minutes.
14 – English
STARTING AND STOPPING
Warm engine
Use the same starting procedure as for a cold engine but
without setting the choke control in the choke position. If
the engine won't start after several attempts, close the
choke and repeat pulling the rope or remove the spark
plug and dry it.
Stop switch
Move the throttle trigger to the idling position and press
the stop switch (red button) until the engine comes to a
complete stop.
IMPORTANT! Exept for an emergency, avoid stopping
the engine while pulling the throttle trigger.