Table of Contents
Advertisement
Table 2-1. Front Panel LEDs (continued)
10Mbps Link / ACT LED
(Right LED)
1000Mbps Link / ACT LED
(Both LEDs)
Reset Button
The Reset button of the GS108T triggers a hardware reset of the switch.
location on the front panel. This action is equivalent to switching the unit power off and back on.
The last saved configuration is loaded into the switch as it resets. To operate the reset button, insert
a device such as a paper clip into the opening to press the recessed button. The front-panel LEDs
should extinguish and light again as the switch performs its Power On Self Test (POST).
Physical Description
GS108T Smart Switch Hardware Installation Guide
n/a
Off
Green
On - Solid
Green
On - Blinking Packets transmission or reception is
n/a
Off
Green
On - Solid
Green
On - Blinking Packets transmission or reception is
v1.0, March 2007
No 10Mbps link is established on the
port
A valid 10Mbps link is established on
the port
occurring on the port, linked at 10Mbps
mode
No 1000Mbps link is established on the
port
A valid 1000Mbps link is established on
the port
occurring on the port, linked at
1000Mbps mode
Figure 2-3
shows its
2-3
Advertisement
Table of Contents
Troubleshooting
