Specifications; Analog Inputs - Peavey VSX 26 Operating Manual

Audio Channels
LED metering
mute Function

ANALOG INPUTS

Input Trim Range
Line Sens Settings
Line Input Impedance
Line max In
Line Input CmRR
Line Input Crosstalk
Line Input Dynamic Range
RTA mic Gain Range
RTA max In
RTA Input Impedance
RTA Input CmRR
RTA Input EIN
RTA Phantom Power
AES Input
OUTPUTS
Output Full Scale
Output Impedance
minimum Load Impedance
Dynamic Range
ANALOG INPUT-TO-OUTPUT
Total Harmonic Distortion
(+ Noise)
Frequency Response
Dynamic Range
Latency
vSX
™

SPECIFICATIONS

3 inputs/6 outputs
2 inputs/6 outputs
Front panel switch and LED for each input and
output
-6 to +6 dB
+24 dBu or -10 dBV
4.4 k ohms
24 dB
55 dB
-90 dB
110 dB A-weighted
+20 to +60 dB
+2 dBu (.98Vrms)
2.2 k ohm
55 dB
-128 dB A-weighted
+48 volts
On XLR 1
+24 dBu
150 ohms
600 ohms
105 dB
0.007 %
20 Hz to 20 kHz
105 dB
< 1 mS
17
26
RTA Mic input can be summed with
Red = -0.5 dBFS and higher (Clip)
Red & Green = -4 to -0.5 dBFS
150 ohm input termination
Approximately 1/2 dB steps
150 ohm input termination
Software selectable between left
channel analog line input
Maximum output @ 600 ohms =
20 Hz to 20 kHz, 22 kHz BW filter,
+4 dBu signal with 20 dB headroom
± 0.5 dBr referenced at 1 kHz
A-weighted, 150 ohm input
Propagation delay from input to
Comments
Line inputs.
LED STATUS:
Green = -4 to -40 dBFS
Off = below -40 dBFS
LED STATUS:
Red = Muted
Off = On
Software controlled
Software selectable
Electronically balanced
20 Hz to 20 kHz
Gain = 60 dB, 22K BW
Electronically balanced
Software controlled
Balanced
Electronically balanced
22.5 dBu
A-weighted
termination
output