Maxtor Installation Manual page 13

Hard Drive Position Tips
Most systems are capable of holding four ATA/IDE devices, two devices on the primary cable
and two devices on the secondary cable or port. Typical configurations are as follows:
New System
2
(See "Installing Hard Drive as a Boot Drive" on page 16.)
Cable Position Device
Primary Master, 0: Boot Drive
Primary Slave, 1: No Device
Secondary Master, 0: CD-ROM
Secondary Slave, 1: No Device
Existing System 1
(See Figure 10 and "Installing Hard Drive as an Additional Hard Drive" on page 21.)
Cable Position Device
Primary Master, 0: Boot Drive
Primary Slave, 1: Additional Storage Drive
Secondary Master, 0: CD-ROM
Secondary Slave, 1: No Device
10 Installing the Hard Drive
Secondary Master, 0
Primary Master, 0
(Boot Drive)
Secondary Slave, 1
Primary Slave, 1
(Additional
Storage)
Secondary
Motherboard
Primary
Connection
Motherboard
Connection
Figure 11. Typical Device Configuration
(CD-ROM)
(Open)