Havis-Shields Universal Side Mount C-TCB-19 Install Instructions

INSTALL INSTRUCTIONS C-TCB-19

TOOLS REQUIRED:

3/16" Allen wrench
3/8" Standard Socket Set
3/8" Ratcheting Wrench

HARDWARE:

QTY DESCRIPTION
1 Pole support assembly
1 Telescoping pole assembly
8 ¼-20 Nylock nut
16 ¼" Flat washer
8 ¼-20 x ¾" Hex head bolt
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit

SUB ASSEMBLY:

1. Confirm receipt of all hardware and components.
2. Determine location to mount TCB.

INSTALLATION:

1. MOUNT SUPPORT BRACKETS:

• With location determined, mark mounting holes using
lower support bracket as template.
• Drill ¼" holes on these marks.
• Attach lower support bracket to desired surface using ¼-20
x ¾" hex head bolts, washers and nylock nuts.
• Following same procedure for lower support bracket mark
and drill holes for upper support bracket.
• Mount optional C-3090, computer-mounting platform, to
telescoping pole assembly using hardware and instructions
provided with C-3090.
UNIVERSAL SIDE MOUNT
Always
Powered drill w/ drill bit set
Open-end wrench set
PART #
CM93071-19
CM93072-1
GSM30016
GSM31005
GSM33001
!
Telescoping pole
assembly
Upper
Support
Bracket
Lower
Support
Bracket
C-TCB-19-INST-8-05