Lowest Cutting Height - RHINO NITRO FN20 Operator's Manual

7.3 Lowest Cutting Height

NOTE: Only operate in the lower position when you
are mowing in an agricultural application, be sure
there are no bystanders, passerby or livestock with
in 300 feet. .
To achieve the lowest possible cutting height, raise
the side skirt from the upper set of holes to the
lower set of holes shown in Figure Op-245
Never crawl under a raised Implement supported solely by the Tractor 3-Point hitch.
Release of the control lever or mechanical failure will result in the Implement falling and
possible injury or death.
underneath to perform repairs and service.
Also raise both skid shoes from the lower holes to
the upper holes as shown in Figure Op-246.
NOTE: Change height back to normal position
before operating or mowing on roadside, ditches
or greenbelts
FN20/FN14 NITRO 02/10
© 2010 Alamo Group Inc.
OPERATION
Always securely block up the Implement before crawling
(S3PT-19)
Operation Section 4-14