Sirius Satellite Radio Stiletto 2 User Manual page 106

Convertible Antenna Cable Routing Procedure
To route the antenna cable in a convertible follow these detailed cable installation
instructions.
1. Bring Cable from
Antenna Into Inside
of Trunk Lid
2. Tape Cable Along
Inside of Lid to
Hinge Strut
1. Bring the cable from the antenna into the trunk at the front edge of the trunk lid. Keep
any bends in the cable loose. Tape or tie the cable along the inside of the trunk lid to
the trunk lid hinge strut.
2. Allow enough slack in the cable so the trunk lid can easily open and close and keep the
cable away from hinges, gears, etc., that could crimp or cut it. Route the cable along
03
Additional Information
6. Bring Cable Out To
Docking Station
Location and Connect
to the Docking Station
3. Tie Cable to Hinge Strut, Allowing
Slack for Lid to Open and Close.
Route Cable Into Cabin
Through Existing Wire
Channel.
5. Bring Cable out from
Trim and Route Under
Carpet to Dashboard
or Console.
4. Route Cable from Trunk
Under Interior Trim, into
Cabin and Towards Front
of Vehicle