Kodak 6J7159 Installation Instructions

A-61661 / January 2010
Installation Instructions for the Kodak Enhanced Printer
Accessory for use with Kodak i4000 Series Scanners
Following are instructions for installing the Kodak Enhanced Printer Accessory for the i4000 Series
Scanners. See the User's Guide for procedures on how to use this accessory.
The Kodak Enhanced Printer Accessory includes:
1 Upper imaging guide
1 Upper flippable background accessory
1 Enhanced Printer carrier
1 Enhanced Printer Black Ink Cartridge
4 Ink blotters
NOTE: Additional ink colors and replacement ink
cartridges can be purchased online at:
scannerstore.Kodak.com.
Before you begin be sure the scanner is turned off.
1. Open the scanner cover.
2. Loosen the screws on each end of the upper
imaging guide and remove it from its position
3. Install the Enhanced Printer imaging guide and
tighten the screws to secure the imaging guide.
Do not over-tighten.
NOTE: Be sure to install the upper imaging guide
in the correct orientation.
4. Loosen the upper flippable background acces-
sory. Use a screwdriver to loosen all four
screws.
5. Unplug the connector to release and remove
the flippable background.
6. Install the flippable background by connecting
the cable and aligning and tightening the
screws in place. Do not over-tighten.
7. Install the ink blotters. See the User's Guide,
Chapter 4, Document Printing, for instructions
for installing and replacing ink blotter strips.
Part No. 6J7159