Initial Settings/Changing Settings - Tanita AM-120E Instruction Manual

Initial Settings/Changing Settings

• If you do not input the initial settings, correct measurements cannot be displayed.
• To change the setting details, press and hold the [setting] button for about 2 seconds while
today's measurement values are displayed in the display screen.
• From the second time onwards, the information that you set previously is displayed.
E.g. Setting to 3pm. Note: The clock uses the 24-hour display.
Setting the Time
1) When batteries are inserted, the
2) Press the
3) Press the SET button to finalize
11
[hour] value flashes.
If you do not press any buttons within
1 minute, the display changes to
[Today's measurements]. To continue
with the settings, press and hold the
SET button for about 2 seconds.
MEMORY button/
MODE button to set the clock.
Press and hold to advance the setting
rapidly.
the setting.
Next, the [minute] digit flashes. Set the
minutes in the same way as for the
hour digit.
Note: To accurately set the time, when
the minute digit is flashing press
the SET button in time with the
time signal.
Continued on next page
Eng