Table of Contents
Advertisement
This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus as set out in the Radio Interference Regulation of the
Canadian Department of Communications.
"Le présent appareil numérique n'èmet pas de bruits radioélectriques dépassant
les limites applicables aux appareils numériques de la class B prescrites dans le
Règlement sur le brouillage radioélectrique édicté par le ministère des
Communications du Canada"
Important Safety Instructions
Please read the following instructions carefully. This manual should be retained
for future use.
1.
To clean the LCD Monitor screen, first, make sure the Monitor is in the power
off mode. Unplug the Monitor from its power source before cleaning it. Do
not spray liquid cleaners directly onto the unit. Stand away from the LCD
Monitor and spray cleaning solution onto a rag. Without applying excessive
pressure, clean the screen with the slightly dampened rag.
2.
Do not place your LCD Monitor near a window. Exposing the Monitor to rain,
water, moisture or sunlight can severely damage it.
3.
Do not place anything on top of the Monitor-to-PC signal cord. Make sure the
cord is placed in an area where it will not be stepped on.
4.
Do not apply pressure to the LCD screen. Excessive pressure may cause
permanent damage to the display.
5.
Do not remove the cover or attempt to service this unit by yourself. You may
void the warranty. Servicing of any nature should be performed only by an
authorized technician.
6.
Safe storage of the LCD Monitor is in a range of -20°C to +60°C (-4°F ~
140°F). Storing your LCD Monitor outside this range could result in
permanent damage.
7.
If any of the following occurs, immediately unplug your Monitor and call an
authorized technician.
•
The power or Monitor-to-PC signal cord is frayed or damaged.
•
Liquid has been spilled onto the Monitor, or it has been exposed to rain.
•
The Monitor has been dropped or the case has been damaged.
8.
Only with use of supplied adaptor, in case of loss or replacement contact the
retailer or service center.
9.
If you lost the power cord that we give, you must purchase the same
configuration/type of power cord (with ground-connection)
Japan：VCTF type, 3 wires or with ground-wire, T-mark approval is
required.
U.S.：VW-1; 18AWG X 3C; SVT with national approval as UL and/or
CSA approval/number(s)
Europe：VDE/ÖVE and/or KEMA approval; H05VV-F, 3G, 0.75mm
equivalent.
Above power cord should bear with the type and manufacturer name on.
ii
2
, or
Advertisement
Table of Contents
