Changing The Basic Settings; Cleaning And Care; Ceramic; Hob Surround - Viva VVK26R8151 Instruction Manual

Changing the basic settings

The hob must be switched off.
Switch on the hob.
1.
Within the next 10 seconds, touch the
2.
4 seconds.
™‚ lights up in the display for the front hotplates.
Touch the symbol repeatedly until the desired indicator
²
3.
appears in the display.

Cleaning and care

The information in this section provides help on how best to
care for your hob.
Suitable maintenance and cleaning products can be purchased
from the after-sales service or in our e-Shop.

Ceramic

Clean the hob after each use. This will prevent spills from
burning onto the ceramic.
Only clean the hob when it has cooled down sufficiently.
Use only cleaning agents which are suitable for ceramic. Follow
the cleaning instructions on the packaging.
Never use:
Undiluted washing-up liquid
■
Detergent intended for dishwashers
■
Scouring agents
■

Rectifying faults

Malfunctions often have simple explanations. Please read the
following notes before calling the after-sales service.
Indicator Fault
Blank There is no power supply.
There is an object on the controls.
is flash-
"
ing
Electronic fault.
+
"§
number
The electronics have overheated and
"ƒ
have switched off the corresponding
hotplate.
* Do not place hot pans close to or on the control panel
14
symbol for
²
Action
Check the household fuse for the appliance. Check whether there is a power
cut by trying other electronic appliances.
Remove the object.
Switch the appliance off and back on again after about 30 seconds using
either the household fuse or the circuit breaker in the fuse box. Contact the
after-sales service if this appears in the display again.
Wait until the electronics have cooled down sufficiently. Then touch a control
for the hotplate.*
Touch the + symbol repeatedly until the desired setting
4.
appears in the display.
Touch the symbol for 4 seconds.
²
5.
The setting is activated.
Switching off
To exit the basic setting, switch off the hob with the main switch
and make new settings.
Harsh cleaning agents such as oven spray or stain remover
■
Abrasive sponges
■
High-pressure cleaners or steam jet cleaners
■
Ground-in dirt can be best removed with a glass scraper,
available from retailers. Please note the manufacturer's
instructions.
You can also obtain a suitable glass scraper from our after-
sales service or from the e-Shop.

Hob surround

To prevent damage to the hob surround, please observe the
following instructions:
Use only warm, soapy water.
■
Do not use harsh or abrasive agents.
■
Do not use the glass scraper.
■