Table of Contents
Advertisement
CLASSIFICATION
Einstufung
SUBJECT
Thema
CUSTOMER'S CODE
EvalPAN4555
6. SERIAL PORTS
The evalboard is equipped with a serial port connector (COM2). The COM port can be linked to
either UART1 (SCI1) or UART2 (SCI2) on the module. This is done with the S1 switch, which has
to be set as follows:
UART1
active
SW1
settings
UART2
active
SW1
settings
Remark: For PAN4555 only UART1 is used, SW1-2 and SW1-4 are have to be set to OFF.
7. RESET
Reset of the testboard and the boards at A,B,C or D can be done with the button named
"RESET" next to the USB socket.
8. BDM CONNECTOR
Reprogramming of PAN4555 can be done via the on-board BDM connector.
For programming, the P&E USB HCS08/HCS12 Multilink adapter USB-ML-12 available through
http://www.pemicro.com/
MC9S08GT60 Controller on the Module can be used.
The 6-pin BDM header has the same pinning as the Multilink adapter cable and is located
between the reset switch and the COM2 Connector.
Please make sure that pin1 of the plug connects to pin1 of the header. The correct device
selection for PAN4555 is a Motorola MC9S08GT60.
European Technology Center
Panasonic Electronic Devices (EUROPE) GmbH
PRELIMINARY
EvalBoard PAN4555
PANASONIC'S CODE
1
2
3
on
off
on
1
2
3
off
on
off
is recommended, but any programmer capable of flashing the
No.
DS-Eval4555-2400
PAGE
Seite
DATE
Datum
4
5
6
off
off
off
4
5
6
on
off
off
APPROVED
CHECKED
genehmigt
geprüft
REV.
01
8 of 16
30.03.2007
7
8
off
off
7
8
off
off
(Table 3)
DESIGNED
Erstellt
Advertisement
Table of Contents
