Autolamps; Instrument Lighting Dimmer; Headlamp Exit Delay - Ford EDGE 2013 Owner's Manual

92

AUTOLAMPS

Autolamp control (if equipped)
lights on for a predetermined amount of time after the ignition switch is
turned to off. You can change the amount of time the lamps stay on by
using the programming procedure in Headlamp exit delay.

INSTRUMENT LIGHTING DIMMER

disconnected, discharged, or a new battery is installed, the dimmer will
set the illuminated components to the maximum setting automatically.

HEADLAMP EXIT DELAY

You can set the delay time to keep the headlamps on for up to three
minutes after the ignition is turned off.
Follow the steps below to change the delay time (Steps 1 through 6
must be done within 10 seconds):
1. Turn the ignition off.
2. Turn the lighting control to the autolamp position.
3. Turn the lighting control to the off position.
2013 Edge (edg)
Owners Guide gf, 4th Printing, November 2012
USA (fus)
Lighting
The autolamp system provides light
sensitive automatic on-off control of
the exterior lights normally
controlled by the headlamp control.
• To turn autolamps on, rotate the
control to
• To turn autolamps off, rotate the
control from the autolamp
position.
The autolamp system also keeps the
Press repeatedly or press and hold
until the desired level is reached.
Note: In the uplevel message center
only, a message will pop up that will
show incrementally where the
dimmer is in relation to the
dimming steps. These steps will also
vary for daytime and night time
dimming.
Note: If the battery is
.