Advertisement
Operation
1 Plug the AV10IRG into an appropriate AC
power source. By plugging in the unit, you
have powered it ON (there is no ON/OFF
function button to press). Power will now
be supplied to the 3 "Always On" outlets
and any components plugged into them can
be turned ON. Each "Always On" outlet's
corresponding LED will illuminate.
2 Use any IR remote to turn ON the GREEN
"Power Save" outlets. Like a gate being
opened, AC power is now present in the 7
"Power Save" outlets.
IMPORTANT IR REMOTE NOTE: Any standard
IR remote will work with the AV10IRG.
There is absolutely no need for additional
programming of this remote as long as it is a
standard IR remote.
3 Once the GREEN "Power Save" outlets have
been powered ON, any components plugged
into these outlets can be switched ON, using
your master remote, their individual remote
controls or manually.
4 After plugging the unit in and plugging in
devices to the "Power Save" outlets, you will
notice that the blue LED panel will display an
amperage reading, based on the connected
load, from the 7 "Power Save" outlets. DO
NOT OVERLOAD the surge suppressor with
more than 15 amps! If the LED panel or
any of the LEDs do not operate, visit www.
tripplite.com/support.
Note: If the surge suppressor is overloaded with more
than 15 amps, the circuit breaker will trip. Reduce the load
connected to the surge suppressor and press in the circuit
breaker reset button located on the side panel to reset the
system.
201003022.indd 6
DO NOT EXCEED 15 AMPS.
6
4/5/2010 9:59:19 AM
Advertisement
