Yealink SIP-T2 Series Auto Provisioning Manual page 77

Permitted
Parameter
Values
(not characters
applicable to
SIP-T42G/T41P
IP phones)
network.ipv6_i
nternet_port.ty 0 or 1
pe =
network.ipv6_
static_dns_en 0 or 1
able =
network.ipv6_ Integer from
prefix = 0 to 128
network.ipv6_i
nternet_port.i IPv6 address
p =
network.ipv6_i
IPv6 address
nternet_port.g
Descriptions
The default value is blank.
It takes effect after a reboot.
It configures the Internet (WAN) port
type for IPv6 when the IP address
mode is configured as IPv6 or
IPv4&IPv6.
0-DHCP
1-Static IP Address
The default value is 0.
It takes effect after a reboot.
It enables or disables the phone to use
manually configured static IPv6 DNS
when Internet (WAN) port type for IPv6
is configured as DHCP .
0-Disabled (use the IPv6 DNS obtained
by DHCP)
1-Enabled
The default value is 0.
It takes effect after a reboot.
It configures the IPv6 prefix when the IP
address mode is configured as IPv6 or
IPv4&IPv6, and the Internet (WAN) port
type for IPv6 is configured as Static IP
Address.
The default value is 64.
It takes effect after a reboot.
It configures the IPv6 address when the
IP address mode is configured as IPv6
or IPv4&IPv6, and the Internet (WAN)
port type for IPv6 is configured as
Static IP Address.
The default value is blank.
It takes effect after a reboot.
It configures the IPv6 default gateway
when the IP address mode is
Appendix
Web Setting Path
PPPoE->Password
Network->Basic->
IPv6 Config
Network->Basic->
IPv6 Config->IPv6
Static DNS
Network->Basic->
IPv6 Config->Static
IP Address->IPv6
Prefix (0~128)
Network->Basic->
IPv6 Config->Static
IP Address->IP
Address
Network->Basic->
IPv6 Config->Static
67