Axis P3353 User Manual page 52

AXIS P3353 Network Camera
Troubleshooting
Lower frame rate than
expected
Status and Network indicator LEDs are flashing red rapidly
Hardware failure
Video and image problems, general
Image unsatisfactory
Motion Detection triggers unexpectedly
Changes in luminance
Storage and disk management problems
Storage disruption
Video cannot be recorded
SD card cannot be mounted
See Performance Considerations, on page 55.
Reduce the number of applications running on the client computer.
Limit the number of simultaneous viewers.
Check with the network administrator that there is enough bandwidth available.
Check in the AMC Control Panel (H.264 tag) that video processing is NOT set to Decode only
key frames.
Lower the image resolution.
The maximum frames per second is dependent on the utility frequency (60/50 Hz) of the Axis
product. See Technical Specifications, on page 53.
Contact your Axis reseller.
Check the video stream and camera settings under Setup > Video > Video Stream and Setup >
Video > Camera Settings.
Motion detection is based on changes in luminance in the image. This means that if there are
sudden changes in the lighting, motion detection may trigger mistakenly. Lower the sensitivity
setting to avoid problems with luminance.
A storage disruption alarm is sent if a storage device is unavailable, removed, full, locked or if other
read or write problems occur. To identify the source of the problem, check the System Log under
System Options > Support > Logs & Reports. Depending on the problem, it might be necessary to
re-mount the storage device.
For information on how to set up a storage disruption alarm, see Events, on page 32.
Check that the SD card is not write protected (that is, read only).
Reformat the SD card and then click Mount.
52