Vector MINI FRIDGE COOLER AND WARMER Owner's Manual & Warranty Information page 5

1
2
3
4
8
USING THE UNIT AS A COOLER
1. Make sure that the unit's HOT/OFF/COOL switch is in the OFF position. Start
vehicle, or turn ignition to "accessory" position.
2.
Insert the DC plug into the converter or vehicle's 12 volt DC accessory outlet and the
other end into socket on cooler/warmer.
3.
Move the HOT/OFF/COOL switch on the unit to the COOL position.
4. The LED COOL indicator will light (GREEN light) to show that the unit is cooling.
Put items into the unit and close the door. Do not overstuff the unit or keep the door
5.
from closing.
Keep unit door closed during operation and re-close it quickly when adding items
6.
to it or removing items from it.
7.
After use, turn the switch to the OFF position and empty the unit.
8. Disconnect the power cord from the accessory outlet and from the unit. Disconnect
the converter from AC. Clean unit as described in the Care & Maintenance section
of this manual.
Store in a cool, dry area out of direct sunlight.
9.
Keep switch in off position for five minutes before changing between hot
10.
or cold.
5
6
HOT
LED
HOT, OFF, COLD
SWITCH
1. E-Z STORE CARRY HANDLE
2. DURABLE AND WEATHER-RESISTANT HOUSING
3. EASY CLEAN ALUMINUM LINER (INSIDE)
4. EASY CLOSE LATCH
5. EXTRA LONG POWER 7' POWER CORD
6. 12 VOLT FUSE PROTECTED DC PLUG FOR
USE WITH VEHICLE, OR PORTABLE
POWER SOURCES
7. COOL/WARM LED INDICATORS
8. AC/DC CONVERTER
5
COLD
LED
12 VOLT
SOCKET
7