Advertisement
2
Attach Shelter to
Frame
–Drape the canopy over the frame (illus. 3)
–Position each corner over the curved
portion of the pole.
–Fully extend each pole by
completing the interlocking of the
shock corded pole sections.
–Insert the brass hook into the hole
near the base of the pole (illus. 4)
–From the inside of the shelter secure
the pole frame to the shelter with the
hook and loop closures.
–Adjust poles to pull the shelter taut
and stake down through the fabric
loops at the end of each pole (illus. 5)
–Adjust hook straps to increase
tautness (illus. 5)
–Attach guy lines to fabric
guy loops at each corner
and stake out (illus. 6)
Things You Should Know
•
Never store shelter, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your shelter. Use separate storage bag provided.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
•
SHELTER POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
•
Do not leave your shelter set-up for weeks at a time, be aware that expo-
sure to the ultraviolet rays of the sun can seriously damage material and/or
cause it to become discolored.
WARNING: Keep all flame and heat sources away from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The fabric will
burn if left in continuous contact with any flame source. The application of
any foreign substance to the tent fabric may render the flame-resistant
properties ineffective.
illus. 3
illus. 4
illus. 5
Insert Brass Hook
Stake through
into hole near the
Stake Loop
base of the pole
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN SRI LANKA
PRINTED IN SRI LANKA
Fabric draped over
partially assembled frame
Hook Strap
Use to adjust
or tighten
canopy
Stake
Stake Loop
illus. 6
Completed shelter with guy
lines staked out
Rev. 10/03
Advertisement
